Fireplace wall

Back to List

Machinist Tool Chest

Ash Night Table

amishness, member

1 user recommends

Nice n' straight

Detail of the little pencil roll in the back and of the leg poking out from the top. Little details make the difference.

Add Comment
Print

A sweet little table with simple lines. This table was made with shop-sawn ash veneer, and birch for the drawer. This is a "modern" post and panel construction, where instead of having a floating panel, the panels are actually a little over an inch thick, i did this by gluing up thicknesses of ply-wood. the reason behind this is that i still have my 1/8 reveal on the outside but the panels are flush with the legs on the inside, greatly simplifying the contruction, meaning i dont have to worry about gluing in runners and kickers. The panels were just simple doweled together.

Ash, Birch

Oil finish, wax

27"H, 18"W, 11 1/2"D

posted in: The Gallery, ash, veneer, night table, post and panel

Add Comment Print

---

Comments (3)

Jurgen01 writes: This is an attractive and functional design that would look good in a variety of primary woods, in addition to ash -- even contrasting primary woods for the legs & the case/drawer would look great. A variety of joinery could be used effectively for this design, as well. Elegant simplicity. Very nice design and execution. Thanks! Posted: 4:43 pm on June 1st

amishness writes: first the 2 side and back panels were doweled to the legs. i then doweled the bottom panel into the sides and back. the top is doweled into the tops of the 3 panels. Quite bomb proof. Posted: 10:30 am on June 1st

baudi writes: What an interesting design! When you say "the panels were...doweled together", do you mean that the side panels were doweled to the top and bottom panels. What about the connection between the panels and the posts? Were those joints doweled too? Posted: 9:25 am on June 1st

You must be logged in to post comments. Click here to login.